In just seven steps this article will guide you on How to Install a Sub woofer in a Factory Stereo. Very often people who are passionate about adding new additional features to their car stereo like sub woofers take the help of audio professionals to do the job. But this job is not at all complicated and can be done without any experience by following simple steps. In this article we shall also discuss the importance of installation of sub woofers, tips and warning for doing this job.

Depth and powerful sound are important for good quality of music. Speakers can be installed at various places inside the car like door panels, dash and rear decks. They enhance the sound effect for higher notes. But to enjoy lower tones adding a sub woofer to a factory stereo is the best choice. Let us see how to do that now.

The first step is the disconnection of grounding cable and the battery of the vehicle. The grounding cable is connected to the vehicle’s frame through the lead that is negative. With the help of a Philips screw driver the clamps of the cables are all loosened and kept separate from the negative lead.

Then the amplifier position is located after which the manual is gone through for any kind of procedure to be followed. The woofer can be placed either in the cargo area at the rear back or the car’s trunk in the case of models like hatch backs or SUV. The speakers are then connected to the output corresponding to each input.

The speaker wires are then routed to the location where the sub woofer is present. The amplifiers may be either close by the sub woofer or even far from them. In such cases the wires are routed to the sub woofers through the carpet layer under the floor of the vehicle. Hiding of the wiring is very essential to give your car a highly professional look.

The other end of the speaker wires are then connected with the input sockets of the sub woofer correctly. Ensure that always positive is connected to positive input and negative with negative input of woofer

After that is done we come to the last step. This seventh step is nothing but reconnecting the ground cable with the vehicle battery’s negative terminal. Fix the clamp on the lead and use the same Philip screw driver which we used for loosening now to tighten the clamp of the cable. Before starting to do this job always make sure if the output from the amplifier can be handled by the sub woofer added.

One must definitely know the simple steps on how to install a sub woofer in a factory stereo, to avoid unnecessary visits to the audio professional.

Want to find out more about Car Hifi, then visit Author Name’s site on how to choose the best Car Audio for your needs.